Technical Briefings
cargo
Unregistered

 
#10
 
No my friend YOU are wrong and please any competitor read this forum the requirement to have a maximum of two 25mm holes in the bottom of the oil containment will most definatly be enforced.

tripod I refer you to page 19 MGP regs Appendix 1 item 8

"Oil Containment
In the interests of safety Standing Regulations will be enforced."

Also I refer to a letter from Harvey Garton dated 27 July 2006 item 1

"All four strokes MUST comply with the oil containmrnt regulation [ACU Reg 13.16}- ie the lower fairing must contain at least half the total oil capacity in the event of an engine failure ; there must be a maximum of two 25mm diameter holes; the holes must have rubber bungs fitted unless the COC declares wet conditions [gaffer/duct tape sealing of holes is not considered adequate."


Now Tripod go read again and then applogise.
05-08-2006, 09:11 AM
Reply


Messages In This Thread
Technical Briefings - by shipleymanx - 31-07-2006, 09:01 AM
[No subject] - by cargo - 31-07-2006, 09:21 AM
[No subject] - by beetroot - 31-07-2006, 07:35 PM
[No subject] - by Anonymous - 31-07-2006, 09:30 PM
[No subject] - by Tomcat - 03-08-2006, 01:04 PM
[No subject] - by tripod - 04-08-2006, 09:37 AM
[No subject] - by cargo - 04-08-2006, 09:48 AM
[No subject] - by tripod - 04-08-2006, 12:43 PM
[No subject] - by tripod - 05-08-2006, 08:58 AM
[No subject] - by cargo - 05-08-2006, 09:11 AM
[No subject] - by tripod - 05-08-2006, 11:23 AM
[No subject] - by thewitch - 05-08-2006, 11:32 AM
[No subject] - by tripod - 05-08-2006, 12:48 PM
[No subject] - by thewitch - 05-08-2006, 12:53 PM
[No subject] - by Anonymous - 05-08-2006, 02:02 PM
[No subject] - by cargo - 05-08-2006, 05:01 PM
Bungs - by an old man returns - 07-08-2006, 08:37 PM
[No subject] - by Anonymous - 07-08-2006, 08:43 PM
Manx Grand Prix Preparation - by chinesespaceman - 11-08-2006, 09:26 AM
[No subject] - by GriffMuss - 11-08-2006, 11:08 PM
[No subject] - by Tomcat - 14-08-2006, 04:57 PM
manx gp - by irishago - 17-08-2006, 09:08 AM



Users browsing this thread: 1 Guest(s)